AeroTech Nozzles
 |
| Reload |
Nozzle throat diam |
|---|---|
| H73 | 0.125 |
| G75 | 0.156 |
| H112 | 0.159 |
| H128 | 0.167 |
| I195 | 0.180 |
| H97 | 0.187 |
| H123 | 0.187 |
| H180 | 0.203 |
| H238 | 0.219 |
| I161 | 0.226 |
| H242 | 0.234 |
| I211 | 0.260 |
| I357 | 0.281 |
| I284 | 0.281 |
| J350 | 0.292 |
| I300 | 0.312 |
| I435 | 0.315 |
| J570 | 0.360 |
Submitted by: Steve Pearson
Too often, AeroTech reload kits are packed with an incorrect nozzle. Using the reload with the wrong nozzle can cause it to under perform or even to CATO. Before you build that next AeroTech reload, check to make sure the right nozzle is packed in the kit. Measure the diameter of the nozzle and compare it to that listed in the table.
1" Outer diameter EZ Access:
| Opening | Reloads |
|---|---|
| Small Exit Diameter | |
| .104 | F37W |
| .125 | F62T |
| .136 | G54W, G61W |
| Medium Exit Diameter | |
| .141 | H73J |
| .156 | G75J |
| .161 | H112J |
| .172 | G104T, G79W |
| .177 | H97J, H242T |
| Large Exit Diameter | |
| .180 | H128W, H165R, H123W, H148R, I154J, I195J |
| .213 | H180W, H210R |
| .228 | H238T, I161W, I218R |
| .266 | H220T, I357T, I211W, I285R, I284W |
| .313 | I300T |
L2 Nozzle
| Opening | Reloads |
|---|---|
| .291 | I200W, H268R, I366R, I600R, J350W, J420R |
| .313 | I435T |
| .359 | J570W |
54MM Medusa
| Center | Outer | Reload |
|---|---|---|
| .266 | J90W | |
| .213 | 3@ .161 | J180T |
| .228 | 2@ .161 | J275W, J315R, J135W |
| .250 | 3@ .196 | J460T |
| .234 | 3@ .182 | J415W, J540R |
| .250 | 6@ .188 | J800T |
| .250 | 3@ .161 | K185W |
| .266 | 3@ .213 | K550W |
| .297 | 6@ .220 | K1100T |
| .266 | 6@ .199 | K700W |
New High Power Single Throat
| Opening | Reload |
|---|---|
| .455 | K695R |
| .562 | K1275R |
Submitted by: John Lyngdal
